Commodore’s SX-64 was an ahead-of-its-time, transportable color pc based around the center technology in the legendary Commodore 64 (book). Sadly, the SX-64’s external computer keyboard is notoriously failure prone. In actuality, of those two keyboards I have, one is completely dead and you scarcely registers a key press (and in reality lately seems to get stuck crucial signs, so it’s much worse). Regrettably, replacement keyboards are amazingly difficult to find and often involves buying another complete system, and this, if you’ve shopped for SX-64’s of overdue, you know isn’t affordable. Fortunately, I did find 1 solution to many an SX-64 proprietor issue, and that is a offering from Jim Brain in Retro Innovations. Retro Innovations AdapterHow the SX-64 is intended to appear. Although the options are a bit perplexing, if you go here, you can pick the SX64 to/from PC alternative. My chosen configuration was as follows: (Configuration: SX64 to/from PC, Joyport Sockets: No, Assembled? Yes). Following a month, I obtained my assembled board, which had been ready-to-go. The plan is simple enough. You take your SX-64 keyboard cable, plug into the SX-64 as usual, then plug the other end to the slot about this gadget. You then plug review azpen a746 7 inch quad core 8gb android tablet – armchair arcade a PS/2 compatible keyboard using a Mini-DIN6 plug into the PS/2 port on this unit. At least that is the concept. Regrettably, it appears that the typical SX-64 cable doesn’t fit into the connector in the board (I tried both of mine), which I supported with Jim Brain via email (I wish he had made this known on the site or perhaps in our prior email addresses ). Though he suggested only using a regular DB25 cable (that it turns out is recommended on his other site), all of my DB25’s didn’t fit . My only option was to snip away the plastic onto the SX-64 keyboard cable connector end, which you may see in the picture. Ugly snipping, but nonetheless, it now matches. As you can also see at the photo, my snipping handiwork along with my Xuron 170-II Micro-Shear Flush Cutters was not great (I had to be particularly careful not to snip any pins! ) , however it gave me an excuse to purchase some documents to fix it up later (they must also be useful for helping beautify a modification I made to the removable lid onto one of my Coleco Adams). How Everything connects

Leave a Reply

Your email address will not be published. Required fields are marked *